Table of Contents
Advertisement
Removal and Replacement Procedures
Removal and Replacement Procedures
1. Align the forehead assembly at the top of the cabinet frame, so the three mounting
holes match the frame holes, and the mounting hooks on each side engage the mounting
slots.
2. Insert the three mounting screws through the frame into the forehead assembly.
Tighten the screws.
3. Attach the PDU harness to the ON/OFF switch lugs as indicated:
Red:
switch terminal 1
Black:
switch terminal 2
White:
switch terminal 6
4. Replace the top cap (refer to top cap replacement).
5. Plug the cabinet power cord into the wall outlet.
Base Cover
Refer to Figure 5-1 while performing these procedures.
Base Cover Removal:
1. Remove the mounting screw located on the top edge, center, of the base cover.
2. Pull the base cover away from the bottom of the cabinet.
Base Cover Replacement:
1. Align the base cover hooks on the bottom of the cabinet frame and roll the base cover
until the mounting holes in the cabinet and base cover align.
2. Insert the mounting screw. Tighten the screw.
Rear Door Hinge
Refer to Figure 5-1 while performing these procedures.
Rear Door Hinge Removal:
1. Remove the rear door (refer to rear door removal).
2. Remove the two mounting screws from the cabinet column (on the upper hinge, also
remove the two mounting screws in the side panel), and lift the door hinge away.
Rear Door Hinge Replacement:
1. Align door hinge with the pressed nuts in the rear cabinet column.
2. Insert the two mounting screws through the hinge into the column (on the upper hinge
insert the two mounting screws into the side panel). Tighten the screws.
5-6
Chapter 5
Advertisement
Table of Contents
