Toro Groundsmaster 5900 Operator's Manual page 43

Figure 43
1. Tensioning cap
2. Spacers (6)
3. Shims (2 top and 2 bottom)
Figure 44
1. Left, front, outside caster
arm
2. Left, front, inside caster
arm
6. If the inside edge is still too high, remove an
additional shim from the bottom of the front,
inside caster arm of the wing mower deck and
1 shim from the front, outside caster arm of the
wing mower deck
7. If the inside edge of the wing mower deck is
too low relative to the outside edge of the front
mower deck, add 1 shim (1/8 inch) to the bottom
of the front, inside caster arm on the wing mower
deck (Figure 43 and
4. Top axle-mounting hole
5. Caster wheel
3. Right, front, inside caster
arm
4. Right, front, outside caster
arm
(Figure 43 and Figure
Figure 44).
Note:
outside edges of both wing mower decks and
the inside edge of the wing mower deck to the
outside edge of the front mower deck again.
8. If the inside edge is still too low, add an additional
shim to the bottom of front, inside caster arm of
the wing mower deck and 1 shim to the front,
outside caster arm of the wing mower deck.
9. Once the mowing height matches at the edges of
the front and wing mower decks, verify that the
mower deck unit pitch is still 7.6 mm (0.3 inch).
g031661
g031663
44).
43
Check the measurement between the