1. Tensioning cap
2. Spacers (6)
3. Shims (2 top and 2 bottom)
5. 5. Install 2 shims onto the shaft as originally
installed and slide the appropriate number of
spacers onto the shaft to get the desired height
of cut.
6. Push the caster shaft through the caster arm.
7. Install the shims (as originally installed) and the
remaining spacers onto the shaft.
8. Install the tensioning cap and tighten it with
the supplied caster-cap wrench to secure the
assembly.
Adjusting the Skids
Adjusting the Inner Skids
Mount the inner skids in the lower position when
operating at heights of cut greater than 51 mm (2
inches) and in the higher position when operating at
heights of cut lower than 51 mm (2 inches).
Adjust the inner skids
Important:
Torque the screw at the front of each
inner skid to 9 to 11 N·m (80 to 100 in-lb).
Figure 38
4. Top axle-mounting hole
5. Caster wheel
(Figure
39).
g031661
40
Figure 39
g032003