Table of Contents
Advertisement
Figure 25
8.
Insert the clevis pins and install the hairpin
cotters.
9.
Rotate the tension rod counterclockwise (finger
tight) to put tension on adjustment.
Adjusting the Skids
Mount the skids in the lower position when operating
at heights of cut greater than 64 mm (2-1/2 inches)
and in the higher position when operating at heights
of cut lower than 64 mm (2-1/2 inches).
decal100-5623nc
Adjusting the Mower-Deck
Rollers
Mount the mower-deck rollers in the lower position
when operating at a height-of-cut greater than 64
mm (2-1/2 inches) and in the higher position when
operating at a height-of-cut lower than 64 mm (2-1/2
inches).
28
Figure 26
Figure 27
g033110
g033113
Advertisement
Table of Contents
