Checking The Rear-Axle-Gearbox Lubricant; Changing The Rear-Axle Lubricant - Toro 30608 30644 Operator's Manual

Checking the
Rear-Axle-Gearbox
Lubricant
Service Interval: Every 400 hours
The gearbox is filled with SAE 85W-140 gear lube.
The capacity is 0.5 L (16 fl oz). Visually inspect for
leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side of
the gearbox and ensure that lubricant is up to
the bottom of the hole
Note:
If the level is low, add enough lubricant to
bring the level up to the bottom of the hole.
Figure 108
1. Gearbox
(Figure 108).
g011488
2. Check/fill plug
Changing the Rear-Axle
Lubricant
Service Interval: After the first 200 hours
Every 800 hours
1. Position the machine on a level surface.
2. Clean the area around the 3 drain plugs; 1 on
each end and 1 in the center
3. Remove the check plugs to ease in the draining
of the oil.
4. Remove the drain plugs and allow the oil to drain
into the pans.
1. Drain-plug location
5. Clean the area around the drain plug at the
bottom of the gearbox
6. Remove the drain plug from the gearbox and
allow the oil to drain into a pan.
Note:
Remove the fill plug to ease in the
draining of the oil.
1. Drain plug
74
(Figure 109).
Figure 109
(Figure 110).
Figure 110
g011509
g011558