Cleaning The Cab Pre-Filter; Cleaning The Air-Conditioning Coil - Toro 30608 30644 Operator's Manual

Figure 134
In-Cab Air Filter
1. Filter
2. Grate
Figure 135
Rear Cab Air Filter
1. Filter
2. Grate
2. Clean the filters by blowing clean, oil-free,
compressed air through them.
Important:
If either filter has a hole, tear, or
other damage, replace the filter.
3. Install the filters and the grate with the
thumbscrews.
g028378
3. Screw
g028379
3. Screw

Cleaning the Cab Pre-Filter

The purpose of the cab pre-filter is to prevent large
debris, such as grass and leaves, from entering the
cab filters.
1. Rotate the screen cover down.
2. Clean the filter with water.
Note:
Do not use a pressure washer.
Important:
If the filter has a hole, tear, or
other damage, replace the filter.
3. Allow the pre-filter to dry before installing it into
the machine.
4. Rotate the filter screen around the tabs until
the latch locks into the latch-mount assembly
(Figure 136).
1. Latch-mount assembly
2. Latch
Cleaning the
Air-Conditioning Coil
Service Interval: Every 250 hours (Clean more
frequently in extremely dusty or dirty
conditions)
1. Shut off the engine and remove the key.
2. Remove the 6 nuts and washers from the bottom
of the rear of the cab
90
Figure 136
3. Screen cover
(Figure 137).
g032951