Cleaning the Cab Pre-Filter
The cab pre-filter prevents large debris, such as grass
and leaves, from entering the cab filters.
1.
Rotate the screen cover down.
2.
Clean the filter with water.
Important:
Do not use a pressure washer.
Note:
If the filter has a hole, tear, or other
damage, replace the filter.
3.
Allow the pre-filter to dry before installing it into
the machine.
4.
Rotate the filter screen around the tabs until
the latch locks into the latch-mount assembly
(Figure
147).
Figure 147
1. Latch-mount assembly
2. Latch
Cleaning the
Air-Conditioning Assembly
Service Interval: Every 250 hours (more frequently in
extremely dusty or dirty conditions).
1.
Disconnect the wire for each fan.
g032951
3. Screen cover
1. Fan
2. Wire
2.
Remove the 2 knobs and remove the fan
assembly.
3.
Open the 4 latches on the air-conditioning
assembly and remove the screen.
1. Air-conditioning coil
2. Latch
4.
Remove the air filters (see
5.
Clean the air-conditioning assembly.
6.
Install the air filters, screen, and fan assembly
(Figure
146,
Figure
7.
Connect the wire for each fan
95
Figure 148
Right fan shown
3. Knob
Figure 149
3. Air-conditioning screen
Figure
146).
148, and
Figure
(Figure
g032323
g032324
149).
148).