Toro Groundsmaster 5900 Operator's Manual page 66

Front Cutting Unit
•
2 caster-fork-shaft bushings
•
5 spindle-shaft bearings (located on the spindle
housing) as shown in
•
3 idler-arm-pivot bushings (located on the
idler-pivot shaft) as shown in
•
4 winglet-deck bushings (located on the
winglet-pivot pins) as shown in
Figure 83
Front Lift Assemblies
•
2 lift-arm bushings
•
2 lift-arm-ball joints
•
2 front deck lift-cylinder pivots
Figure 84
Wing Cutting Units (Each Wing)
•
4 caster-fork-shaft bushing
(Figure 83)
Figure 83
Figure 83
Figure 83
(Figure 84)
(Figure 84)
(Figure 84)
(Figure 85)
•
3 spindle-shaft bearings (located on the spindle
housing) as shown in
•
2 idler-arm-pivot bushings (located on the
idler-pivot shaft) as shown in
g033268
Wing Lift Assemblies (Per Wing)
•
3 main lift-arm bushings
•
1 lift-cylinder bushing
g009247
66
Figure 85
Figure 85
Figure 85
(Figure 86)
(Figure 86)
Figure 86
g009151
g009248