Lowering The Front-Deck Winglets - Toro Groundsmaster 5900 Operator's Manual

2. Remove the straps and braces securing the
wing decks for shipping.
2
Lowering the Front-Deck
Winglets
Parts needed for this procedure:
1 Right deck cover
1 Left deck cover
2 V-belt
Procedure
1. Remove the nuts securing the front and rear stop
bolts to the right winglet-deck mounts
1. Winglet
2. Hinge pin
3. Stop bolt
2. While supporting the right winglet, remove the
front and rear stop bolts from the deck mounts
(Figure 3).
Note:
Leave the eccentrics positioned between
the deck mounts.
3. Lower the winglet to the operating position.
(Figure
Figure 3
4. Eccentric
5. Upper hole
6. Deck mounts
4. Install the front and rear stop bolts through the
upper-mounting holes and eccentrics
Note:
Ensure that the stop bolt engages the tab
on the hinge pin.
3).
1. Winglet
2. Hinge pin
3. Bolt
5. Install the nuts securing the stop bolts.
Note:
Do not tighten the nuts at this time.
6. Repeat this procedure on the left winglet.
7. Install the winglet belts as follows:
A. Start the belt around the winglet-spindle
pulley and the front-deck-spindle pulley
(Figure
g009013
1. Winglet-spindle pulley
2. Front-deck-spindle pulley
17
Figure 4
4. Eccentric
5. Lower hole
5).
Figure 5
3. Idler pulley
(Figure 4).
g008868
g009155