Toro Groundsmaster 5900 Operator's Manual page 85

8. Route the new belt around the spindle pulleys
and idler-pulley assembly
Figure 126
9. Adjust the stop screw on the idler pulley and
tighten the jam nuts.
10. Install the belt covers.
Replacing the Wing Cutting-Unit
Belts
Note:
To remove the lower belt, you must remove
the upper belt first.
1. Lower the cutting unit to the floor.
2. Remove the belt covers from the top of the
cutting unit and set the covers aside.
3. Remove the bolts securing the hydraulic motor
to the cutting unit
4. Lift the motor off the cutting unit and lay it on top
of the cutting unit.
5. Using a ratchet wrench or similar tool, move the
idler pulleys away from the drive belt to release
the belt tension and allow the belt to slip off the
pulleys (Figure 127).
(Figure 126).
114-0922
(Figure 125).
decal114-0922nc
1. Idler pulleys
6. Remove the old belt from around the spindle
pulleys and idler pulley.
7. Route the new belt around the spindle pulleys
and idler-pulley assembly
Figure
85
Figure 127
(Figure 128
129).
Figure 128
Right deck
Figure 129
Left deck
g009009
and
decal114-0974nc
decal114-4883nc