Checking The Fluid Levels; Greasing The Machine - Toro Groundsmaster 5900 Operator's Manual

Figure 7
1. Winglet
2. Hinge pin
3. Stop bolt
3. Rotate the forward eccentric until it reaches
maximum clearance with the inner-slot surface
of the winglet-pivot bracket.
4. Rotate the rear (closest to the traction unit)
eccentric until the outside blade tip is about 3
mm (1/8 inch) higher than the desired height of
cut (Figure 7).
Note:
There is a notch on the eccentric hex,
which is 180° from the lobe on the eccentric
cam (Figure 8). Use the notches to reference
the location of the lobes when adjusting the
eccentrics.
Figure 8
1. Eccentric notch
5. Tighten the bolt and nut for this eccentric to 149
N·m (110 ft-lb).
g008868
4. Eccentric
5. Upper hole
g009153
6. Adjust the forward eccentric until it just makes
contact with the inner slot surface of the
winglet-pivot brackets.
7. Tighten the bolt and nut for this eccentric to 149
N·m (110 ft-lb).
8. Repeat the procedure on the opposite winglet.
6

Checking the Fluid Levels

No Parts Required
Procedure
1. Check the engine-oil level before starting the
engine; refer to
(page 69).
2. Check the hydraulic-fluid level before starting
the engine; refer to
(page 86).
3. Check the cooling system before starting the
engine; refer to
System (page
7

Greasing the Machine

No Parts Required
Procedure
Grease the machine before use; refer to
(page 65).
Important:
Failure to properly grease the
machine will result in premature failure of critical
parts.
19
Checking the Engine-Oil Level
Checking the Hydraulic Fluid
Checking the Engine-Cooling
80).
Lubrication