Table of Contents
Advertisement
Belt Maintenance ................................................ 77
Servicing the Alternator Belt ............................. 77
Belt................................................................ 77
Tensioning the Blade-Drive Belts ...................... 78
Replacing the Blade-Drive Belt ......................... 78
Hydraulic System Maintenance ........................... 79
Hydraulic System Safety................................... 79
Servicing the Hydraulic System ........................ 79
Cutting Unit Maintenance ..................................... 83
the Upright Position....................................... 83
Pivoting the Center Cutting Unit Down .............. 83
Adjusting the Cutting-Unit Pitch ........................ 84
Servicing the Caster-Arm Bushings .................. 84
Bearings........................................................ 85
Covers .......................................................... 86
Blade Maintenance .............................................. 86
Blade Safety ..................................................... 86
Checking for a Bent Blade ................................ 86
Blade(s) ........................................................ 87
Blade(s) ........................................................ 87
Correcting a Cutting Unit Mismatch................... 88
Cab Maintenance ................................................. 89
Cleaning the Cab .............................................. 89
Cleaning the Cab Air Filters .............................. 89
Cleaning the Cab Pre-Filter .............................. 90
Cleaning the Air-Conditioning Coil .................... 90
Storage ................................................................... 91
Storage Safety.................................................. 91
Preparing the Machine for Storage ................... 91
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or missing.
1. Grease
58-6520
Safety
This machine has been designed in accordance with
ANSI B71.4-2017 and with EN ISO 5395 when you
complete the setup procedures and install the CE kit,
per the Declaration of Conformity.
General Safety
This product is capable of amputating hands and
feet and of throwing objects. Always follow all safety
instructions to avoid serious personal injury.
•
Read and understand the contents of this
Operator's Manual before starting the engine.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine without all guards
and other safety protective devices in place and
functioning properly on the machine.
•
Keep your hands and feet away from rotating
parts. Keep clear of the discharge opening.
•
Keep bystanders and children out of the operating
area. Never allow children to operate the machine.
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position, Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
Improperly using or maintaining this machine can
result in injury. To reduce the potential for injury,
comply with these safety instructions and always
pay attention to the safety-alert symbol
means Caution, Warning, or Danger-personal safety
instruction. Failure to comply with these instructions
may result in personal injury or death.
decal58-6520
1. Crushing hazard, hand-read the instructions before
servicing or performing maintenance.
4
, which
93-6674
decal93-6674
Advertisement
Table of Contents
