Toro Groundsmaster 5900 Operator's Manual page 54

Figure 65
•
If you are authorized by your company, you need
the PIN code to perform the recovery-regeneration
process.
Preparing to Perform a Parked or Recovery
Regeneration
1. Ensure that the machine has fuel in the tank for
the type of regeneration you are performing:
•
Parked Regeneration: Ensure that you
have 1/4 tank of fuel before performing the
parked regeneration.
•
Recovery Regeneration: Ensure that you
have 1/2 tank of fuel before performing the
recovery regeneration.
2. Move the machine outside to an area away from
combustible materials.
3. Park the machine on a level surface.
4. Ensure that the traction control or motion-control
levers are in the N
5. If applicable, lower the cutting units and shut
them off.
6. Engage the parking brake.
7. Set the throttle to the low I
Performing the Regeneration
Note:
For instructions on unlocking protected menus,
refer to Accessing Protected Menus on the Software
Guide for you machine.
1. On the
MAIN MENU
navigate to the
SERVICE
4 to select the
SERVICE
position.
EUTRAL
position.
DLE
, press button 1 or button 2 to
option, and press button
entry (Figure 66).
g214647
2. On the
SERVICE
2 to navigate to the
press button 4 to select the
(Figure 67).
If an
UNAVAILABLE MESSAGE
InfoCenter, perform the recommended actions
described in the unavailable message table of
Regeneration Unavailable Messages (page
3. On the regeneration screen, press button 4 to
start the regeneration process
54
Figure 66
menu, press button 1 or button
option, and
REGENERATION
REGENERATION
displays in the
Figure 67
(Figure
g214884
entry
50).
g214887
68).