Contour Call (Cycle62) - Only For G Code Program - Siemens sinumerik 840D sl Operating Manual

Procedure for deleting a contour element
8.3.6

Contour call (CYCLE62) - only for G code program

Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
2. Labels
3. Subprogram
4. Labels in the subprogram
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
5. Enter the parameters in the input screen or delete the element and
select a new element.
6. Press the "Accept" softkey.
The desired contour element is inserted in the contour or changed.
1. Open the part program or ShopTurn program to be executed.
2. Position the cursor on the contour element that you want to delete.
3. Press the "Delete element" softkey.
4. Press the "Delete" softkey.
The contour is in the calling main program.
The contour is in the calling main program and is limited by the labels that have been
entered.
The contour is located in a subprogram in the same workpiece.
The contour is in a subprogram and is limited by the labels that have been entered.
Programming technology functions (cycles)
8.3 Contour turning
315