Creating A Joblist - Siemens sinumerik 840D sl Operating Manual

14.4.6

Creating a Joblist

For every workpiece, you can create a job list for extended workpiece selection.
In the job list, you specify instructions for program selection in different channels.
Syntax
The job list contains the SELECT select instructions.
SELECT <program> CH=<channel number> [DISK]
The SELECT instruction selects a program for execution in a specific NC channel. The
selected program must be loaded into the working memory of the NC. The DISK parameter
enables the selection of external execution (CF card, USB data carrier, network drive).
● <Program>
● <Channel number>
● [DISK]
Comment
Comments are identified in the job list by ";" at the start of the line or by round brackets.
Template
You can select a template from Siemens or the machine manufacturer when creating a new
job list.
Executing a workpiece
If the "Select" softkey is selected for a workpiece, the syntax of the associated job list is
checked and then executed. The cursor can also be placed on the job list for selection.
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Absolute or relative path specification of the program to be selected.
Examples:
– //NC/WCS.DIR/SHAFT.WPD/SHAFT1.MPF
– SHAFT2.MPF
Number of the NC channel in which the program is to be selected.
Example:
CH=2
Optional parameter for programs that are not in the NC memory and are to be executed
"externally".
Example:
SELECT //remote/myshare/shaft3.mpf CH=1 DISK
14.4 Creating a directory/program/joblist/program list
Program management
595