Siemens sinumerik 840D sl Operating Manual page 34

Introduction
1.4 User interface
Third line
Display
The machine manufacturer settings determine which program controls are displayed.
34
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
Description
Display of channel status.
If several channels are present on the machine, the channel
name is also displayed.
If only one channel is available, only the "Reset" channel status
is displayed.
With touch operation, you can change the channel here.
Display of channel status:
The program was aborted with "Reset".
The program is started.
The program has been interrupted with "Stop".
Display of active program controls:
PRT: no axis motion
DRY: Dry run feedrate
RG0: reduced rapid traverse
M01: programmed stop 1
M101: programmed stop 2 (name varies)
SB1: Single block, coarse (program stops only after blocks
which perform a machine function)
SB2: Data block (program stops after each block)
SB3: Single block, fine (program also only stops after blocks
which perform a machine function in cycles)
Channel operational messages:
Stop: An operator action is usually required.
Wait: No operator action is required.
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Turning