Dell EMC PowerEdge VRTX User Manual page 119

• To enable CMC to use the specified Active Directory Domain Controller server addresses, select Specify Domain Controller
Addresses . These server addresses are the addresses of the domain controllers where the user accounts and the role
groups are located.
4. Click Apply to save the settings.
NOTE: You must apply the settings before continuing. If you do not apply the settings, the settings are lost when
you navigate to the next page.
5. In the Standard Schema Role Groups section, click a Role Group. The Configure Role Group page is displayed.
6. Specify the group name, domain, and privileges for a role group.
7. Click Apply to save the role group settings and then click Go Back To Configuration page.
8. If you have enabled certificate validation, you must upload the domain forest root certificate authority-signed certificate to
CMC. In the Manage Certificates section, type the file path of the certificate or browse to the certificate file. Click Upload to
upload the file to CMC.
NOTE: The File Path value displays the relative file path of the certificate you are uploading. You must type the
absolute file path, which includes the full path and the complete file name and file extension.
The SSL certificates for the domain controllers must be signed by the root certificate authority-signed certificate. The root
certificate authority-signed certificate must be available on the management station accessing CMC.
9. If you have enabled Single Sign-On (SSO), in the Kerberos Keytab section, click Browse, specify the keytab file and click
Upload. When the upload is complete, a message is displayed indicating a successful or failed upload.
10. Click Apply. The CMC Web server automatically restarts after you click Apply.
11. Log out and then log in to CMC to complete the CMC Active Directory configuration.
12. Select Chassis in the system tree, and navigate to the Network tab. The Network Configuration page is displayed.
13. Under Network Settings, if Use DHCP (for CMC Network Interface IP Address) is selected, select Use DHCP to obtain
DNS server address.
To manually enter a DNS server IP address, clear Use DHCP to obtain DNS server addresses and type the primary and
alternate DNS server IP addresses.
14. Click Apply Changes.
The CMC Standard Schema Active Directory feature configuration is complete.
Configuring Active Directory With Standard Schema Using RACADM
At the RACADM command prompt, run the following commands:
• Using config command:
racadm config -g cfgActiveDirectory -o cfgADEnable 1
racadm config -g cfgActiveDirectory -o cfgADType 2
racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupName <common name of
the role group>
racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupDomain <fully
qualified domain name>
racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupPrivilege <Bit Mask
Value for specific RoleGroup permissions>
racadm config -g cfgActiveDirectory -o cfgADDomainController1 <fully qualified domain
name or IP address of the domain controller>
racadm config -g cfgActiveDirectory -o cfgADDomainController2 <fully qualified domain
name or IP address of the domain controller>
racadm config -g cfgActiveDirectory -o cfgADDomainController3 <fully qualified domain
name or IP address of the domain controller>
NOTE: Enter the FQDN of the domain controller, not the FQDN of the domain. For example, enter
servername.dell.com instead of dell.com.
NOTE:
At least one of the three addresses is required to be configured. CMC attempts to connect to each of the configured
addresses one-by-one until it makes a successful connection. With Standard Schema, these are the addresses of the
domain controllers where the user accounts and the role groups are located.
racadm config -g cfgActiveDirectory -o cfgADGlobalCatalog1 <fully qualified domain
name or IP address of the domain controller>
119