Logging In To The Device; Logging In To The Device Using Stelnet/Telnet - Huawei R240D Hardware Installation

R240D
Hardware Installation and Maintenance Guide

3.1 Logging In to the Device Using STelnet/Telnet

You can log in to the device using STelnet V2 or Telnet to configure, manage, and maintain
the device in the CLI.
Before logging in to the device, complete the following tasks:


The following table lists the default configuration of the device. You are advised to change the
default user name and password on your first login.
Table 3-1 Default configuration of the device
Parameter
User name
Password
IP address
Subnet mask
The following example uses the default parameters and is used for reference only.
Step 1 Use network cables and a LAN switch to connect the PC to the network interface of the
device.
Step 2 Assign the PC with an IP address on the same network segment as the default IP address of
the device so that the PC and device are reachable to each other.
Issue 03 (2016-01-26)
3
 By default, only the STelnet V2 service is enabled on the device.
 Telnet has security vulnerabilities. You are not advised to enable the Telnet service.
Power on the device.
Prepare network cables used to connect device interfaces.
If the device is already online on the AC, you can remotely log in to the AC on a local terminal and run
the display ap all command to check the IP address of the device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Logging In to the Device

Default Setting
admin
admin@huawei.com
169.254.1.1
255.255.0.0
3 Logging In to the Device
19