Huawei R240D Hardware Installation page 40

R240D
Hardware Installation and Maintenance Guide
Figure 5-16 Fitting the jacket of the connector onto the Ethernet cable
Step 2 Remove a 30 mm (1.18 in.) long section of the jacket, cut off the nylon twine inside the jacket,
and cut a no more than 5 mm (0.20 in.) cleft in the jacket, as shown in Figure 5-17.

When you remove a section of the jacket, do not damage the shield layer of the
twisted-pair cable.

When you remove the shield layer, do not damage the insulation of the twisted-pair cable.
Figure 5-17 Removing the jacket of a twisted-pair cable (unit: mm (in.))
Step 3 Fit the metal shell onto the twisted-pair cable. The shield layer is covered by the metal shell,
as shown in Figure 5-18.
Issue 03 (2016-01-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Appendix
34