Panasonic KX-NS1000 Programming Manual page 829

Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
PC Programming Manual References
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - BRI Port
Feature Guide References
2.1.1.4 Multiple Subscriber Number (MSN) Ringing Service
Tenant Number
Specifies the tenant number, to determine the Time Table by which calls are distributed depending on the time
of day.
Value Range
1–32 or 1–128
Note
The maximum number of tenants depends on the System Capacity Selection setting made when the
Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the maximum
number of tenants is 128. If the Standard Type or IP-Extension Type was selected, the maximum number
of tenants is 32. For details, refer to "5.4.1 Easy Setup Wizard" in the Installation Manual.
Maintenance Console Location
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
PC Programming Manual References
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - BRI Port
10.4 PBX Configuration—[2-4] System—Week Table
Feature Guide References
2.1.1.4 Multiple Subscriber Number (MSN) Ringing Service
UM Service Group No.
Specifies the Service Group number sent to the Unified Messaging system when the incoming call destination
is the floating extension number of a UM group.
The Service Group number is used to allow the Unified Messaging system to send the applicable greeting
message to the caller.
Value Range
None, 1–64
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
PC Programming Manual 829