Installing The Time/Date Battery - Brother PA-TDU-001 Quick Setup Manual

g
While holding the touch panel display
securely, open the RD Roll
compartment top cover. Secure the
touch panel display with the four screws
(1) included as accessories to attach the
touch panel display to the printer.
Be sure to use the screws included with
the touch panel display. The screws
previously installed in the printer are a
different shape.
h
Close the RD Roll compartment top
cover by pressing down on the centre,
until it clicks into place.
Installing the Time/Date
Battery
A time/date battery is provided as an
accessory to be used for backing up the touch
panel display time. The battery will maintain
the settings for the internal clock. The battery
will be consumed even if the printer is not
used for a long period of time.
1
 Only use recommended batteries in
the printer. Other batteries may
cause damage to the printer.
 Dispose of the battery at an
appropriate collection point, not in
the general waste stream. In
addition, be sure to observe all
applicable federal, state, and local
regulations.
 When storing or discarding the
battery, wrap it (for example with
cellophane tape), to prevent it from
short-circuiting.
(Battery insulation example)
1 Cellophane tape
2 Time/Date Battery
 We recommend replacing the
battery every two years.
 If the clock is reset while power is
supplied to the printer, replace this
battery. When replacing the lithium
battery, purchase a CR2032 battery
(recommended manufacturers:
Hitachi Maxell, Ltd., FDK
Corporation, Panasonic
Corporation, Sony Corporation,
Toshiba Corporation and VARTA
Microbattery Inc.).
1
2
7