Table of Contents
Advertisement
Chapter 10 Miscellaneous Options
Introduction
This chapter includes commonly used bar codes to customize how data is transmitted to the host device.
The decoder ships with the settings shown in the
Appendix A, Standard Default Parameters
values suit requirements, programming is not necessary.
There are two ways to change a parameter value:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a "parameter send" command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer's
Guide for detailed instructions for changing parameter values using this method.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
To return all features to default values, scan the
bar code menus, default values are indicated with asterisks (
Miscellaneous Options Default Table on page 10-2
for all host device and miscellaneous scanner defaults). If the default
Set Default Parameter on page
*
Disable No Read
*
Indicates Default
4-4. Throughout the programming
*
).
Feature/Option
(00h)
Hex Value
(also see
Advertisement
Table of Contents
