Table of Contents
Advertisement
4 - 12 Symbol PL4507 Decoder Integration Guide
Power Mode (RS-232 Hosts Only)
Parameter # 80h
Select whether or not the decoder enters Low Power consumption mode after a decode attempt. In Continuous On
mode, the decoder does not enter this low power state.
Continuous On
Time Delay to Low Power Mode
Parameter # 92h
This parameter sets the time the decoder remains active after decoding. After a scan session, the decoder waits
this amount of time before entering Low Power mode.
NOTE This parameter only applies when Power Mode is set to Low Power.
To program a different value for this parameter than those provided here, see
Power Mode with SSI on page
*1 Second
(00h)
6-7.
(11h)
*Low Power Mode
(01h)
Using Time Delay to Low
5 Seconds
(15h)
Advertisement
Table of Contents
