User Preferences Parameter Defaults - Motorola Symbol PL4507 Integration Manual

User Preferences Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. To change any parameter value, scan the appropriate bar
code(s) provided in the User Preferences section beginning on
NOTE See
miscellaneous default parameters.
User Preferences Default Table
Table 4-1
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Trigger Modes
Motion Enhancement for Presentation Mode
Motion Enhancement Performance Setting
Time Delay to Motion Enhancement Sleep Mode
Power Mode
Time Delay to Low Power Mode
Picklist Mode
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Beep After Good Decode
Continuous Bar Code Read
Multicode Mode
Multicode Expression
Appendix A, Standard Default Parameters
Parameter
page 4-4.
for all user preferences, hosts, symbologies, and
Parameter
Default
Number
Restore Defaults
ECh Enable
91h Medium
8Ch High
8Ah Level
F1 A6h Disable
F1 8Ah Standard
F1 96h 1 Minute
80h Low Power
92h 1.0 Sec
F0h 92h Disabled Always
88h 9.9 Sec
89h 0.6 Sec
38h Enable
F1h 89h Disable
F1h A5h Disable
F1h 95h 1
User Preferences 4 - 3
Page
Number
4-4
4-5
4-6
4-7
4-8
4-9
4-9
4-10
4-12
4-12
4-14
4-14
4-15
4-15
4-16
4-16
4-17