Table of Contents
Advertisement
4 - 14 Symbol PL4507 Decoder Integration Guide
Picklist Mode
Parameter # F0h 92h
Picklist mode enables the decoder to decode only bar codes aligned under the center of the laser aiming pattern.
Select one of the following picklist modes:
•
Disabled Always - Picklist mode is always disabled.
•
Enabled Always - Picklist mode is always enabled.
NOTE With Picklist Mode enabled, the decode aiming pattern turns on even when the
page 5-6
*
Disabled Always
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
Numeric Bar Codes
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan Cancel on page D-3.
Decode Session Timeout
is disabled.
(00h)
that correspond to the desired on time. Provide a leading zero for single digit numbers. For
Decode Aiming Pattern on
Enabled Always
(02h)
Appendix D,
Advertisement
Table of Contents
