General Specification - Toshiba AJ65VBTCU-68ADVN User Manual

3 SPECIFICATION
3 SPECIFICATION
This chapter provides the specifications of the AJ65VBTCU-68ADVN/ADIN.

3.1 General Specification

Table 3.1 indicates the general specifications of the AJ65VBTCU-68ADVN/ADIN.
Item
Usage ambient temperature
Storage ambient temperature
Usage ambient humidity
Storage ambient humidity
Vibration durability
Shock durability
Usage environment
Usage height
Installation area
1
Over-voltage category *
2
Pollution level *
*1 Indicates the location where the device is connected from the public cable network to the device structure wiring
area.
Category II applies to the devices to which the power is supplied from a fixed equipment.
Surge withstand voltage for devices with up to 300V of rated voltage is 2500V.
*2 This is an index which indicates the degree of conductive object generation in the environment Pollution level 2 is
when only non-conductive pollution occurs.
A temporary conductivity caused by condensation must be expected occasionally.
*3 Do not operate or store the PLC in the environment where the pressure applied is equal to greater than the
atmospheric pressure at the altitude of 0m.
Doing so may cause a malfunction. Please consult our branch office when the PLC is to be operated under
pressure.
3 - 1
Table 3.1 General specification
Frequency
10 to 57Hz
Conforming to JIS B 57 to 150Hz
3502, IEC 61131-2
When there is continuous vibration
Frequency
10 to 57Hz
57 to 150Hz
Conforming to JIS B 3502, IEC61131-2 (147m/s
Specification
0 to 55°C
-20 to 75°C
10 to 90%RH, no condensation
10 to 90%RH, no condensation
When there is intermittent vibration
Acceleration Amplitude
0.075mm
—
(0.0030inch)
2
9.8m/s
Acceleration Amplitude
0.035mm
—
(0.0013inch)
2
4.9m/s
2
, 3 times each in 3 directions)
No corrosive gas
Less than 2000 m (less than 6562 ft.)
Within the control board
Less than II
Less than 2
MELSEC-A
Sweep count
—
10 times in each direction
X, Y, Z (80 minutes)
—
3 - 1
3