Cutter Mechanism - Brother RH-9820 Service Manual

6. ASSEMBLY
・
Assemble each part in the order shown in the illustration.
・ Parts indicated by

6-1. Cutter mechanism

* Carry out assembly steps <1> to <8> in "6-25. Lubrication and greasing and routing the oil tubes" before
carrying out the assembly in "6-1. Cutter mechanism".
* Refer to the detailed descriptions on the next page for details on A to D in the illustration.
* Apply the grease specified by Brother (MOLYKOTE LONGTERM W2 manufactured by Dow Corning
Corporation) in the places indicated by
Insert so
that the
ground
surface
touches.
Refer to "7-14.
Adjusting the
axial play of
the hammer".
Install so
that it is
not
twisted.
55
are part of the same assembly.
.
C
Adjust so that the cutter
driving shaft (2) turns
smoothly with no play, and
then fully tighten the two
socket bolts (4).
<Used with
-02-L1422, L1826,
L2230 specifications>
Place onto the
cutter sensor pin
(18).
Refer to "7-16-2.
Making fine adjustments
to the knife position".
RH-9820
D
A
B
Insert
from
top of
arm.
<For -00, -01,
-02-L2634,
<For
L3442
-02-L1422,
specifications>
L1826, L2230
specifications>
0785B