Table of Contents
Advertisement
Erasing Codes
CAUTION: Erasing the Diagnostic Trouble Codes may allow the
scan tool to delete not only the codes from the vehicle's on-board
computer, but also "Freeze Frame" data and manufacturer specific
enhanced data. Further, the I/M Readiness Monitor Status for all
vehicle monitors is reset to Fail status. Do not erase the codes before
the system has been checked completely by a technician.
1)
If you decide to erase the DTCs, use the UP/DOWN scroll
buttons to select Erase Codes from Select Function menu and
press the Y button.
If the scan tool is not connected or no communication is
established with the vehicle yet, then refer to Reading Codes
from 1 to 7 at Paragraph 3.1.
2)
A warning message comes up asking for your confirmation.
< V2.6 USB-V1.9 SERIAL SOFTWARE
< V2.6 USB-V1.9 SERIAL SOFTWARE
16627 --100
CAN BUS
Solenoid Valve (A)
For Boost Pressure
Control (N75):
Malfunction: P0243
Select Function
1) Read Codes
►2) Erase Codes
3) ECU Information
4) Readiness Test
13
13
01/10
↓
V
Advertisement
Table of Contents
