Table of Contents
Advertisement
5)
Wait a few seconds till the following screen appears.
If a message "Service reset failed!" comes up, repeat the
procedure from Step 3 or use Auto Detect to detect service
automatically.
If the message "Service reset failed!" does not go away,
Verify that the ignition is ON;
Check if the scan tool's OBD II connector is securely
connected to the vehicle's DLC;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back on.
If the scan tool still fails to perform oil service reset, contact
your local distributor or the manufacturer's customer service
department for assistance.
< V2.6 USB-V1.9 SERIAL SOFTWARE
< V2.6 USB-V1.9 SERIAL SOFTWARE
Select Function
►01) Oil Insp. Light
02) Set Insp. 1
03) Set Insp. 2
Oil Service
RESET OK!
Press any key to con.
33
33
V
Advertisement
Table of Contents
