Oil Service - Sealey VS862 Instructions Manual

4) If you do wish to proceed to erase the codes, then press the Y
button.
5) If the codes are cleared successfully, an "ERASE DONE!"
confirmation will show on the display. Press any button to return
to previous menus.
6) If the codes are not cleared, then an "ERASE FAILURE!"
message will appear. Press the N button to return to previous
menus.

3.3 Oil Service

1) Turn the ignition off.
2) Locate the vehicle's 16-pin Data Link Connector (DLC).
3) Plug the OBDII connector to the vehicle's DLC.
4) Turn the ignition on. But do not start the engine.
5) Press the Y button. The Main Menu will be observed on the
display.
6) Use UP/DOWN scroll button to select Oil Service from the menu,
and press the Y button.
If the scan tool fails to communicate with the vehicle, a
"LINK ERROR!" message shows up on the display.
Verify that the ignition is ON;
Check if the scan tool's OBD II connector is securely
connected to the vehicle's DLC;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back on.
< V2.6 USB-V1.9 SERIAL SOFTWARE
< V2.6 USB-V1.9 SERIAL SOFTWARE
Main Menu
1) VW/AUDI
2) OBDII/EOBD
►3) Oil Service
4) System Setup
20
20
V