HP 9000 Installation Manual page 13

D class and r class i/o card installation

Hide thumbs Also See for 9000:

D. Remove the EMI

D Class servers that have the Hot-Swap Module installed will have an EMI cover

Cover

installed over the processor/memory card. To remove the EMI cover:

1. Loosen the two notches at the bottom of the EMI cover from the tabs on the

2. Pull the EMI cover down slightly until the two notches at the top of the cover

3. Loosen and remove the SCSI ribbon cable from the Fast/Wide SCSI card.

4. Remove the other end of the SCSI ribbon cable from the connector on the hot-

E. Remove the I/O

1. Loosen and remove two (2) screws that secure the I/O card retainer bracket to

Card Retainer

Bracket

processor/memory card by pushing up and slightly flexing the EMI cover until

the notches come loose.

come loose from the tabs at the top of the server cabinet.

swap backplane, and set the EMI cover and ribbon cable aside.

the I/O card guide.

I/O Card Installation Guide

I/O Card Installation Procedure