HP 9000 Installation Manual page 24

D class and r class i/o card installation

Hide thumbs Also See for 9000:

I/O Card Installation Guide

I/O Card Installation Procedure

K. Replace the EMI

If your server came with an EMI cover installed, and you removed it in step E, you

Cover

must reinstall it. To reinstall the EMI cover:

1. Place the EMI cover and SCSI ribbon cable close enough to the upper cabinet to

2. Insert the two upper notches of the EMI cover onto the tabs at the top of the

3. Flex the EMI cover slightly to insert the two notches at the bottom of the EMI

4. Connect the lower end of the SCSI ribbon cable on the EMI cover to the

connect the upper end of the ribbon cable to the connector on the Fast/Wide

SCSI card.

server cabinet.

cover onto the tabs of the processor/memory card.

backplane connector on the Hot-Swap Module.