HP 9000 Installation Manual page 33

2 R Class I/O Card Installation
Required Tools
I/O Card Installation Overview
To install I/O cards, you must turn off system power, and disassemble the system to
gain access to the cabinet interior. An overview of the procedure is given below:
A. Shut down the operating system.
B. Turn off power to the system.
C. Remove the front bezel.
D. Remove the top panels.
E. Remove the EMI cover.
F. Remove the I/O card retainer bracket.
G. Remove the I/O slot cover plate from bulkhead.
H. Set I/O card configuration.
I. Install HSC cards.
J. Install EISA cards.
K. Replace the I/O card retainer bracket.
L. Replace the EMI cover.
M. Replace the top panels.
N. Replace the front bezel.
O. Refer to I/O card-specific documents.
After completing all desired procedures, you should proceed to the I/O Card
Installation Verification section later in this chapter for procedures to verify that
I/O cards have been correctly installed.
• Small flat-bladed screwdriver
• Torx driver, #15
• Torx driver, #10
• Phillips screwdriver.
2- 1