HP server rx4610 Service Manual page 104

Chapter 6
3. Pull the chassis out of the rack.
CAUTION
4. Loosen the two thumbscrews in the back of the chassis that secure the rear cover.
5. Read the documentation included with the accessory board and follow any special instructions.
6. Identify the accessory slot number to be used. See Figure 30.
NOTE
7. Lift the rear cover to expose the non-hot plug PCI adapter board cover.
8. Loosen the screw that secures the non-hot plug PCI adapter board cover.
9. Grasp the cover by its exposed, long side and lift the cover over the non-hot plug boards away
from the chassis. You can completely remove the cover if you want by unseating the slot hinge.
Access is now available to the two non-hot plug PCI slots and the Legacy I/O board.
Wear a wrist-strap and use a static-dissipating work surface connected to the
chassis when handling components. Ensure the metal of the wrist-strap contacts
your skin.
PCI Hot Plug Slots
Figure 30. Accessory Slots
Refer to the Readme file for the Tested Products List that shows specific slot
recommendations for a particular PCI board type.
Non PCI Hot Plug Slots
Replacing Parts
96