HP server rx4610 Service Manual page 138

Chapter 6
9. Install the non-hot plug PCI adapter board cover by aligning the slotted hinge into the chassis
housing, closing the cover, and securing the cover screw.
10. Close the rear part of the top cover and secure it by tightening the two thumbscrews in the back.
11. Attach any peripherals to the rear panel of the Legacy I/O board.
12. Install the power cords to the system.
13. Push the system into the equipment rack.
14. Power-on the system.
15. Turn on all peripheral devices connected to the system that you shut down during this
procedure.
Replacing Parts
130