ETP4830-A1
User Manual
Step 3 Check whether the battery voltage and system output voltage are the same as the voltages
displayed on the SMU LCD. If not, ask the technical support personnel to rectify the fault.
Step 4 Set the battery and load circuit breakers based on the site requirements.
Step 5 Observe the power system for 15 minutes. If no alarm is generated on the SMU LCD, the
voltage and current for batteries and loads are normal. In this case, clean and leave the site.
----End
Issue 06 (2014-02-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Commissioning
40