Safety Cut-Off; Timer - Silvercrest 278854 Operating Instructions Manual

NOTE
►
Safety cut-off
■
■
NOTE
►

Timer

You can preselect a time period from 5–180 mins., after which the respective
hob 1/2 will switch off .
1) Begin the cooking procedure (in power or temperature mode) as explained
2) Press the "TIME" button 7/r. "0" appears on the display 0/u.
The display 0/u now alternately shows the set power level/temperature and
the time that remains until switch-off .
After this time, the respective hob 1/2 switches off automatically.
■ 12 │
GB
If no button is depressed for a period of two hours, the appliance will switch
off even if one or both of the hobs 1/2 is/are in operation. If you wish
to wish to cook a dish for more than two hours, or to keep food warm
for more than two hours, adjust the desired time using the timer (see the
"Timer" section). In this way, times of up to three hours can be set.
For safety reasons, the pan detection switches the appliance off automatically
(into standby mode) if you remove the cooking vessel from the hob 1/2
or fail to place a cooking vessel on it.
If you remove the cooking vessel from the hob 1/2, there will be 20 beeps.
The appliance will then switch off . If you place the cooking vessel back on
the hob 1/2 before the 20 beeps have fi nished, the previously defi ned
settings will be retained.
As soon as you remove the cooking vessel from the hob 1/2, "E0" is
shown on the display. After approx. one minute, the "E0" disappears and
the appliance switches itself off . If the hob is still at a temperature in excess
of 50°C, "-H-" will show on the respective display until the temperature
drops below 50°C.
above.
Set the desired time.
If you briefl y press the "+" q/i or "-" 9/z buttons, the time increases
or decreases by 5 minutes each time the button is depressed. If you press
and hold down the "+" q/i or "-" 9/z button, the time increases or
decreases by 10 minutes for each time the button is depressed.
SDI 3500 A1