Dell S5000 Deployment/Configuration Manual page 39

Dell Networking S5000: Deployment of a Converged Infrastructure with FCoE
Now the virtual disk on the PowerVault storage array displays in Windows just like a typical hard drive.
Note, no special configuration was needed on the HBA.
Figure 43: Remote storage on PowerVault as seen in Windows as drive 'F:'
To observe that the storage ports and HBA ports are logged into the fabric, you can use the 'nsshow'
command on the Brocade FC switch as shown below in Figure 44. Note that since the command is
run on the fabric A FC switch, only four storage ports and one HBA port is logged into the fabric as
expected. We would see similar (with different WWPNs) on the fabric B FC switch.
39 Deployment of a Converged Infrastructure with FCoE
Deployment/Configuration Guide