Fujitsu F-022 User Manual page 9

F-022_E2kou
F-022.book 7 ページ ２０１１年２月２４日 木曜日 午後２時４２分
Do not put F-022 terminal in hot water, use it in a sauna or apply
･
hot airflow (from a hair dryer etc.) to it.
･ Do not move in water or slam the terminal against the surface of
water with F-022 terminal opened.
If you put the terminal in tap water or in water of swimming pool,
･
be sure to have it within 30 minutes.
･ When you use the terminal in swimming pool, obey rules of the
facility.
F-022 terminal does not float on water.
･
･ Do not leave water on F-022 terminal. May short-circuit the power
jacks, or in a cold region, water may freeze causing malfunction.
Do not leave water on the microphone, earpiece or speaker. Such
･
water may interfere with talking.
･ If the rear cover is damaged, replace it. Water may enter inside
from a damaged section causing troubles such as electric shocks
or corrosion of the battery.
･ If F-022 terminal gets wet with water or other liquids with the
external connection jack cap or rear cover open, the liquid may
get inside the terminal causing electric shocks or malfunction.
Stop using F-022 terminal, turn the power OFF, remove the
battery and contact a D-PHONE-specified repair office.
If rubber gasket on the external connection jack cap or inner lid is
･
damaged or deformed, replace it at D-PHONE-specified repair
office.
FUJITSU does not guarantee actual operations under all states.
Malfunctions deemed to be caused by inappropriate operation by
the customer are not covered by the warranty.
◆ Wash F-022 terminal
Wash the terminal with tap water while holding the external
connection cap. Do not rub the terminal.
Press here
Do not apply water flow stronger than allowed (e.g., such water
･
flow that gives you pain when applied to your skin directly from
a faucet or shower).
Wash it using room-temperature tap water with your hand, the
･
rear cover of F-022 terminal installed and locked, and the external
connection jack cap held in position.
Do not use any brush, sponge, soap, cleaning material, etc.
･
When mud or soil is attached to F-022 terminal, do not open or
･
close the terminal. Instead, rinse the terminal clean by shaking it
several times in tap water in a bucket and then flush away with
running water.
After flushing away, wipe off water with a dry cloth, drain, and
･
dry naturally as described below.
7
Chapter 1 Introduction