Table of Contents
Advertisement
7.5.5
Setting calibration points
Figure 7-5
Carry out the calibration commands at the end of the quick start:
1. Carry out the "Set calibration weight 0" command. The "Calibration weight 0" defined in
step 4 is now visible in the display.
2. Place the "Calibration weight 1" defined in step 4 on the scale construction, and execute
the "Set calibration weight 1" command.
3. If an "Calibration weight 2" was selected:
Place "Calibration weight 2" defined in step 4 on the scale construction, and execute the
"Set calibration weight 2" command.
4. Calibration of the scale is now complete. Return to the start screen by clicking on the
house icon.
SIWAREX WP231
Manual, 07/2014, A5E31238908A-02
7.5 5 minute quick start with the operator panel and the Ready-for-Use software
Quick start step 5a
Commissioning
49
Advertisement
Table of Contents
