Dr 10 Load Cell Parameters; Overview - Siemens SIWAREX WP231 Manual

Scale parameters and functions

8.11 DR 10 load cell parameters

8.11 DR 10 load cell parameters
8.11.1

Overview

The parameters of the analog load cells must be checked prior to the automatic calibration
and modified if necessary. Only the parameters identified by bold font and asterisk (*) need
be entered.
Procedure
● Check the parameters and modify them as required
● Transfer the data record to the scales
● Adjust the scales
Table 8- 10 Assignment of data record 10
Variable Note
Data record Contains no. of data record
number
Length Data record length information
Application Information about which applica-
tion the DR belongs to
Version identi- Information on current data record
fier version
Number of load Number of analog load cells (in-
cells ternal variable)
1)
50/60 Hz tog- 50/60 Hz toggling
gling
(Page 100)
Number of Number of support points
support points
(Page 100)
1)
Reserve
Load cell char- Characteristic value of the load
acteristic value cell (n) [mV/V], the mean value is
(Page 100) used if there is more than one cell.
1)
Zero point Zero point offset in uV/V, the
offset mean value is used if there is
1)
more than one cell. (internal varia-
ble)
Rated load of a Rated load of a load cell
load cell
(Page 100)
1)
Reserve Reserve
Reserve Reserve
Reserve 2 Reserve
Reserve 3 Reserve
Reserve 4 Reserve
Parameter for calculation of calibration points with theoretical calibration
1)
98
Type Length Rw
(bytes)
USHORT 2 r
USHORT 2 r
USHORT 2 r
USHORT 2 r
USHORT 2 rw
USHORT 2 rw
USHORT 2 rw
USHORT 2 rw
FLOAT 4 rw
FLOAT 4 rw
FLOAT 4 rw
FLOAT 4 rw
FLOAT 4 rw
SHORT 2 rw
USHORT 2 rw
FLOAT 4 rw
Default Min. Max.
10 - -
44 - -
101 - -
1 1 65635
1 1 6
0 0 1
0 0 8
0 0 0
2 >0.1 10
0 -1000 1000
60 - -
0 - -
0 - -
0 - -
0 - -
0 - -
Manual, 07/2014, A5E31238908A-02
Modbus
registers
1400
1401
1402
1403
1404
1405
1406
1407
1408
1410
1412
1414
1416
1418
1419
1420
SIWAREX WP231