Programmable Outputs; Output Programming - Bosch Solution 2000 Installation Manual

Control Panel
16

Programmable Outputs

The control panel has four fully programmable outputs on the main printed circuit board and
one programmable output that operates the codepad buzzer. The four outputs are set by
default to operate as an alarm device, fire alarm verification, strobe, and internal screamer.
The control panel supports additional 16 outputs via two output expanders.
Programmable outputs require four parameters to operate correctly.
Parameter
Event Type
Polarity
Time Base/Time
Multiplier
Table 16.1: Output Parameters
16.1

Output Programming

Item
Output 1 (Default = Horn Speaker)
Event Code
Event Code
Polarity
Time Base
Time Base Multiplier
Time Base Multiplier
Output 3 (Default = Strobe – Reset After 8 hrs.)
Event Code
Event Code
Polarity
Time Base
Time Base Multiplier
Time Base Multiplier
Codepad Buzzer (Default = Entry/Exit Warning and
Day Alarm)
Event Code
Event Code
Bosch Security Systems, Inc.
Location Default New
0436 1
0437 14
0438 0
0439 0
0440 0
0441 0
0448 2
0449 0
0450 6
0451 4
0452 0
0453 8
0460 0
0461 13
Description
The Event Type specifies when an output is activated. Enter the
code for the Output Event Type into the two corresponding
locations for the output.
Polarity determines whether the output operates for the duration
of the event, pulses for the duration, operates only once (one
shot), or latches on.
The Time Base and Time Multiplier parameters determine how
long and how often the output operates.
Item
Output 2 (Default = Fire Alarm With Verification)
Event Code
Event Code
Polarity
Time Base
Time Base Multiplier
Time Base Multiplier
Relay Output (Default = Sirens Running)
Event Code
Event Code
Polarity
Time Base
Time Base Multiplier
Time Base Multiplier
Installation Guide
Programmable Outputs | en
Location Default New
0442 2
0443 7
0444 10
0445 2
0446 1
0447 5
0454 1
0455 15
0456 1
0457 0
0458 0
0459 0
2017.10 | 03 | F.01U.298.026
117