Toro Reelmaster 3100-D Service Manual page 121

Removal
NOTE: Note position of hydraulic fittings when remov-
ing from the reel motors. Position is critical to properly
reconnecting hydraulic hoses.
1. Remove reel motor from the cutting unit (see Reel
Motor Removal and Installation in Chapter 7 − Cutting
Units).
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
2. Remove hydraulic hoses from reel motors using Fig-
ure 45 as a guide.
3. If hydraulic fittings are to be removed from reel mo-
tor, mark fitting orientation to allow correct assembly.
Reelmaster 3100−D
Installation
1. If hydraulic fittings were removed, install fittings to
reel motor using marks made during the removal pro-
cess to properly orientate fittings.
2. Install reel motor to the cutting unit (see Cutting Unit
Removal and Installation in Chapter 7− Cutting Units).
3. Install hydraulic hoses to reel motors using Figure 45
as a guide.
Page 4 − 73
Hydraulic System