Bedbar Removal And Installation - Toro Reelmaster 3100-D Service Manual

Bedbar Removal and Installation

32
24
31
30
29
28
20
19
1. Rubber bushing
2. Flanged bushing
3. Jam nut
4. Compression spring
5. Washer
6. Not used
7. Not used
8. Spring arm
9. Bedbar adjuster
10. Not used
11. Not used
12. Not used
Bedbar Removal
1. Turn bedbar adjuster to loosen bedknife to reel con-
tact. Unscrew bedbar adjuster (left−hand threaded)
while loosening jam nut from the compression spring
until the bedbar fitting is clear of the bedbar yoke.
2. Remove cap screws, weights, and cover gasket from
the bearing housing (Fig. 26).
3. Remove capscrew, lock washer, flat washer, and
spacer from the end of the bedbar.
4. Loosen both adjusting lock nuts on the adjusting
housing (Fig. 28).
SPA Cutting Units
25
27
35
34
13. Adjuster spacer
14. Not used
15. Bedbar pivot
16. Grease fitting
17. Bedbar fitting
18. Not used
19. Flange bushing
20. Bushing
21. Lock nut
22. Hex nut
23. Adjusting housing
24. Lock nut
1 2 3 5 4 5
Figure 27
5. Remove both carriage bolts and nuts from the ad-
justing housing (Fig. 28).
6. Remove both carriage bolts and nuts from the bed-
bar housing. Remove bedbar from the cutting unit.
7. Remove adjusting housing and bedbar housing from
the bed bar. Remove bedbar washer.
8. Sharpen or replace bedknife as necessary (see
Bedknife Replacement and Grinding).
Page 7 − 18
17
15 13
2
8
1
16
36 33
19
25
25. Carriage bolt
26. Not used
27. Bedbar washer
28. Bedbar housing
29. Spacer
30. Flat washer
31. Lock washer
32. Cap screw
33. Bedbar
34. Bedknife
35. Screw
36. Bedbar yoke
Reelmaster 3100−D
9
20
21
22
23
24