Specifications - Toro Reelmaster 3100-D Service Manual

Specifications

MOUNTING: All cutting units are supported by equal
length independent lift arms and are interchangeable to
all three cutting unit positions.
CONSTRUCTION: 5 or 8 blades of 7 inches (18 cm) di-
ameter welded to stamped steel spiders. Reels are
mounted on greaseable self−aligning ball bearings. A
cutting unit has a reel of either 27 inches (69 cm) in
length or 32 inches (81 cm) in length.
HEIGHT OF CUT RANGE:
Floating Cutting Unit − 1/4 to 1−3/4 inches
(6.4mm to 44.4mm).
Fixed Cutting Unit − 1/2 to 2−5/8 inches
(12.7 mm to 65.6 mm).
POWER: Reel motors allow easy removal from or instal-
lation onto the cutting unit. Cutting units can be driven
from either end.
HEIGHT−OF−CUT &
Height−of−cut adjustment is made with the rollers by a
quick locating pin and/or threaded micro−adjustment.
BEDKNIFE AND BEDBAR ADJUSTMENT: A single
knob (SPA) screw adjustment for bedknife to reel is lo-
cated at the center of the bedbar.
CUTTING UNIT LIFT: Hydraulic lift has an automatic
reel shut off. All units are controlled from one lever.
SUSPENSION SYSTEM: A fully floating suspension
with hydraulic counterbalance. L−I−N−K−S
unit suspension system provides fore and aft oscillation.
Main center pivot allows side−to−side oscillation. With
optional Fixed Kit (Part No. 93−6915), cutting units can
be locked into fixed (fore/aft) position for use with skids
or anti−scalp rollers.
SPA Cutting Units
ROLLER ADJUSTMENT:
TM
cutting
Figure 1
CLIP FREQUENCY: With variable speed set to maxi-
mum rpm:
5 blade at 1040 reel rpm moving at 5 mph (8.1 km/h)
5 blade at 1040 reel rpm moving at 6 mph (9.7 km/h)
8 blade at 1040 reel rpm moving at 5 mph (8.1 km/h)
8 blade at 1040 reel rpm moving at 6 mph (9.7 km/h)
OPTIONAL EQUIPMENT:
27−inch Cutting Units
Full Roller Kit
Sectional Roller Kit
Wiehle Roller Kit
Anti−Scalp Roller Kit
Roller Scraper Kit
Wiehle Roller Scraper Kit
Comb Kit
32−inch Cutting Units
Sectional Roller Kit
Wiehle Roller Kit
Full Roller Kit
Anti−Scalp Roller Kit
Roller Scraper Kit
Wiehle Roller Scraper Kit
Both Models of Cutting Units
Fixed Kit
Skid Kit
Backlapping Brush Assembly
Gauge Bar Assembly
Bedknife Screw Tool
Page 7 − 2
1 inch (25.4 mm) clip.
1.20 inch (30.5 mm) clip.
0.63 inch (16.0 mm) clip.
0.76 inch (19.3 mm) clip.
Model No. 03440
Model No. 03445
Model No. 03450
Model No. 03447
Part No. 60−9560
Part No. 94−5082
Part No. 67−9400
Model No. 03476
Model No. 03475
Model No. 03479
Model No. 03477
Model No. 03478
Part No. 94−5081
Part No. 93−6915
Part No. 94−3664
Part No. 29−9100
Part No. 13−8199
Part No. 51−0880
Reelmaster 3100−D