Toro Reelmaster 3100-D Service Manual page 300

Reel Assembly (cutting units with aluminum side plates)
17
8
18
Antiseize
Lubricant
(Bearing OD)
RIGHT
FRONT
1. Bedbar assembly
2. Cutting unit frame
3. Flange bushing (2 used)
4. Plastic washer (4 used)
5. Metal washer (2 used)
6. Bedbar pivot bolt (2 used)
NOTE: Refer to Reel Assembly Service later in this sec-
tion for information on replacing cutting reel seals and
bearings.
DPA Cutting Units
2
13
27 to 33 ft−lb
(37 to 44 N−m)
14
Pack
with Grease
9
(both ends)
Antiseize
Lubricant
(Bearing OD)
Figure 36
7. Lock nut (2 used)
8. RH side plate
9. LH side plate
10. Weight
11. Cap screw (2 used)
12. O−ring
NOTE: Removal of the cutting reel requires removal of
the left side plate from the cutting unit frame. The right
side plate does not have to be removed from the frame.
Page 8 − 30
1
15
3
12
10
11
13. Cutting reel assembly
14. Wire spring
15. Flange nut (3 used per side plate)
16. Shoulder bolt (3 used per side plate)
17. Cap screw (2 used)
18. O−ring
Reelmaster 3100−D
4
16
4
7
5
6
Antiseize
Lubricant