Fujitsu ETERNUS DX60 Operation Manual page 69

Name
MAC Address
MAC Address and IP Address
IP Address and Port Number
Point
-
Specify "1" for Restriction on the number of detached ports of the switch. The number "1" is set by default.
The Restriction on the number of detached ports indicates the allowable number of ports disconnected from members making
up a bonding port. When the number of detached ports is less than the restriction number, the bonding port is disabled. For
example, if number "1" is specified for the Restriction on the number of detached ports and 4 ports make up a bonding port,
when all the 4 ports become unavailable, the bonding port is disabled. When all the ports are recovered, the bonding port
gets enabled.
-
The function required for LAN switch varies depending on the operating mode of bonding port.
Refer to the ETERNUS Disk storage system manuals for the function required for switch by operating mode.
NAS Interface (network)
IP Address for Access
Sets the IP address used for the NAS interface.
VLAN ID
Sets the tag VLAN ID configured for the NAS interface.
By setting the VLAN ID for the NAS interface, the NAS interface can be additionally allocated for ports that other NAS interfaces
have allocated.
Note
-
When multiple NAS interface are assigned to the same port using the VLAN ID, the NAS interface must all be in different
subnets.
-
Port VLAN is not supported for connection between ETERNUS Disk storage system and switch.
See
Refer to "Create NAS Interface" in the
Note
-
When the same subnet is assigned to the same CM, the behavior will be to communicate using only a specific port.
-
Where the network is allocated in an Active-Active connection form, it is necessary to set the same network address between CM.
-
To create a NAS interface, allocate a new NAS interface to NAS ports and then restart the service to access the shared folder by
the CIFS protocol. Before the restart process is completed, the shared folder is not accessible from the existing NAS interface by
the CIFS protocol. Wait a few moments to access it again.
This is determined using an EXCLUSIVE OR of the sender and recipient MAC
addresses.
This is determined using an EXCLUSIVE OR of the sender and recipient MAC
addresses and IP addresses.
This is determined using an EXCLUSIVE OR of the sender and recipient IP addresses
and port numbers.
ETERNUS SF Web Console Guide for information on settings using the Web Console.
- 55 -
Explanation