Changing Nas Interface - Fujitsu ETERNUS DX60 Operation Manual

-
Owner/Group of Shared Folder
-
Writing Authority
-
Hosts Permitted Access
-
Hosts Denied Access (when the protocol is CIFS or both CIFS and NFS)
Note
-
When the configuration of a shared folder is changed, sharing will temporarily be suspended and it will not possible to access
the shared folder. When the changes to the shared folder are complete, sharing will be automatically resumed.
-
When data access encryption is enabled, clients that do not support SMB 3.0 cannot access the shared folder.
See
Refer to "Change Shared Folder" in the
using the Web Console.
4.6.4.3

Changing NAS Interface

The values of the NAS interface will be changed.
The values that can be changed are as follows:
-
IP Address
-
RIP Setting
-
Port
-
Redundant port
-
Member ports of bonding port
-
Operating mode of bonding port
Information
-
Only when a new port is set to the NAS interface to which the port is not set, the setting of the port can be changed.
-
The following ports cannot be selected as the port:
-
Member ports of bonding port
-
The following ports cannot be selected for Redundant ports:
-
Port of same CM as assignment Allocation port
-
Redundant port of other port
-
Member ports of bonding port
-
The following ports cannot be selected as member ports of bonding port:
-
Port of CM different from the master port
-
Port to which a NAS interface has already been assigned
-
Duplicated port
-
Master ports of bonding port
-
It is not possible to delete all member ports and disable port bonding.
ETERNUS SF Web Console Guide for information on how to make changes to the shared folder
- 59 -