Fujitsu ETERNUS DX60 Operation Manual page 92

-
$INS_DIR: "Program Directory" specified at the ETERNUS SF Manager installation
-
$ENV_DIR: "Environment Directory" specified at the ETERNUS SF Manager installation
Perform the following procedure to change the port numbers used by Express.
1.
Open the file "%SystemRoot%\system32\drivers\etc\services" with a notepad.
2.
Pick out the entry of a service name to be changed to change its entry port number.
A port number can be entered between 1024 and 65535. However, a port number from 5001 to 32768 is recommended.
# <service name> <port number>/<protocol> [aliases...] [#<comment>]
#
stgxfws 1226/tcp
esfmanagerweb 9855/tcp
sscruiserm 24916/tcp
3.
Save the "%SystemRoot%\system32\drivers\etc\services" file and close it.
4.
Edit httpd.conf file if the port number used by Web Console is changed.
1.
Open the "$INS_DIR\Common\sys\apache\conf\httpd.conf" file with text editor.
2.
Replace the port number (9855) in red letters with the other port number listed immediately after the Listen directive.
Listen 9855
3.
Save the "$INS_DIR\Common\sys\apache\conf\httpd.conf" file and close it.
5.
Restart services.
1.
Execute the following batch on the Management Server to stop the ETERNUS SF Manager services.
$INS_DIR\Common\bin\Stop_ESFservice.bat
2.
Execute the following batch on the Management Server to start the ETERNUS SF Manager services.
$INS_DIR\Common\bin\Start_ESFservice.bat
6.
Create a server information change instruction file on the Management Server, then execute the stgxfwcmmodsrv command
with the -f option specified to change the port numbers.
[Example] In the case that name of the server information change instruction file is "c:\acm\modfile".
$INS_DIR\ACM\bin\stgxfwcmmodsrv -f c:\acm\modfile
7.
Restart the Management Server.
See
Refer to "stgxfwcmmodsrv (Server Information Change Command)" in the
corresponding to the operating system of the Management Server for information on the stgxfwcmmodsrv command and the server
information change instruction file.
Changing Port Numbers Used in Web Console
The Web Console uses the following ports internally.
Port Number Protocol
28005 tcp
28009 tcp
28443 tcp
Port numbers used inside Web Console
ETERNUS SF AdvancedCopy Manager Operation Guide
Note
- 78 -