Create Nas Interface - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.8 NAS Management
4.8.4

Create NAS Interface

This function creates NAS interfaces. Up to 160 NAS interfaces can be created.
This function is used in a Unified Storage environment.
If the NAS interface creation has not been completed successfully, wait for the ETERNUS DX S3 series status to
return to normal and then try again.
To use the Active-Active connection, specify different IP addresses on the same subnetwork for the ports of
each CM that will be duplicated.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to create a NAS interface is as follows:
Procedure
1
Click [Create] in [Action].
2
Specify parameters for the NAS interface
508
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.4.7.3 Create NAS Interface" (page
"Appendix B Create NAS Interface" (page
890).
1002).
P2X0-1270-13ENZ0